Komatsu D375A-6 (SN from 60001) Crawler Dozers (Japan) Field Assembly Manual (GEN00097-03)

Illustrated factory Field Assembly Manual for Komatsu Crawler Dozers Models D375A-6.

This manual will assist you in for your crawler dozer.
You can use a Windows, Mac, or Android device to view this manual. You only need to have a PDF reader installed.

Covered Models (Japan):
   D375A-6 (SN: 60001-)

Format: PDF, 224 pages
Language: English
Table of Contents:
   Preface
   Specifications
   Precautions for field assembly
   Disposal of removed parts
   Assembly procedure, necessary equipment, and schedule
   Layout of kit
   Style for transportation
   Table of tools for field assembly
   Tightening torque
   Coating materials list
   Selection of wire ropes used for assembly
   A. Assembly
      A-1 Installation of chassis
      A-2 Installation of undercover
      A-3 Installation of pivot shaft
      A-4 Installation of undercarriage
      A-5 Adding oil to recoil chamber and pivot chamber
      A-6.1 Installation of engine air inlet hood
      A-6.2 Installation of engine air pre-cleaner (if equipped)
      A-7 Installing direction of exhaust pipe
      A-8 Installation of blade lift cylinder
      A-9 Installation of ripper
      A-10 Installation of track
      A-11 Assembly of blade
      A-12 Installation of blade
      A-13 Installation of operator's cab
      A-14 Installation of rear monitor camera (if equipped)
      A-15 Installation of additional cab lights (if equipped)
      A-16 Installation of ROPS
      A-17 Installation of VHMS, ORBCOMM antenna
      A-18 Installation of revolving warning lamp to top of ROPS (if equipped)
      A-19 Check track tension
      A-20 Check fuel, coolant and lubricants
      A-21 Bleeding air from hydraulic cylinders
      A-22 Lubricating
      A-23 Installation of fuel quick charge piping (if equipped)
   M. Check and maintenance procedures after completion of assembly
      M-1 Check and adjustment of operator's cab
      M-2 Inspection of machine monitor
      M-3 Checking operation of dual tilt mechanism (If equipped)
      M-4 Setting procedure for USER ADJUST MODE
      M-5 Setting procedure for maximum cooling fan speed
      M-6 Replacement of return filter (Replacement of standard filter -> special flushing parts)
      M-7 Flushing of hydraulic circuit, and bleeding air from hydraulic cylinders (Part 1)
      M-8 Replacement of return filter (Replacement of special flushing parts -> standard filter)
      M-9 Bleeding air from hydraulic cylinders (Part 2)
   APPENDIX 1. Installation procedure for spill guard (Installation by welding)
   APPENDIX 2. Precautions for initialization procedures for VHMS controller
   Field assembly inspection report