Komatsu WA800-3-LC (SN from A50001) 4WD Wheeled Loaders (USA) Field Assembly Manual (CEAWD00100)

Illustrated factory Field Assembly Manual for Komatsu 4WD Wheeled Loaders Models WA800-3-LC.

This manual will assist you in for your 4wd wheeled loader.
You can use a Windows, Mac, or Android device to view this manual. You only need to have a PDF reader installed.

Covered Models (USA):
   WA800-3-LC (SN: A50001-)

Format: PDF, 102 pages
Language: English
Table of Contents:
   CHART OF SEPERATED UNITS
   DIMENSIONS AND WEIGHTS OF SEPARATED UNITS
   TRANSPORTATION BY LAND
      SPECIFICATIONS
      WHEN TRAVELING UNDER OWN POWER
      TRANSPORTATION BY TRAILER
      TRAILERS REQUIRED TO MOVE MACHINE
   SERVICE REFILL CAPACITIES
   ORDER, FACILITIES AND SCHEDULE FOR ASSEMBLY
   WORK SPACE LAYOUT DIAGRAM
   TOOLS AND EQUIPMENT REQUIRED
      TOOLS REQUIRED
      EQUIPMENT REQUIRED
      LIFTING TOOLS REQUIRED
      OIL, GREASE, FUEL, PAINT, ETC
      PROTECTIVE WEAR
      LOCAL MANUFACTURING DIAGRAM FOR TOOLS
   PROCEDURE FOR FIELD ASSEMBLY
      A-1 SETTING BARE MACHINE ON SUPPORTS
      A-2 ASSEMBLY OF REAR AXLE
      A-3 ASSEMBLY OF FRONT AND REAR DRIVE SHAFTS
      A-4 INSTALLATION OF FRONT AXLE
      A-5 ASSEMBLY OF FUEL TANK
      A-6 ASSEMBLY OF LADDER (LEFT/RIGHT)
      A-7 ASSEMBLY OF CAB
      A-8 ASSEMBLY OF HAND RAIL
      A-9 ASSEMBLY OF REAR TIRE AND WHEEL ASSEMBLIES
      A-10 ASSEMBLY OF BATTERY BOXES
      A-11 ASSEMBLY OF COUNTERWEIGHT
      A-12 ASSEMBLY OF EXHAUST PIPE
      A-13 ASSEMBLY OF HANDRAILS AND REAR ACCESS STEPS
      A-14 ASSEMBLY OF BOOM
      A-15 ASSEMBLY OF FRONT FENDERS
      A-16 ASSEMBLY OF FRONT LAMP ASSEMBLIES
      A-17 ASSEMBLY OF ROPS CANOPY
      A-18 ASSEMBLY OF BUCKET
      A-19 ASSEMBLY OF FLOOR MAT
   PROCEDURE FOR TESTING ASSEMBLY
      M-1 BLEEDING AIR FROM WHEEL BRAKE CIRCUIT
      M-2 GREASING WORK EQUIPMENT AND CHASSIS
      M-3 ADJUSTING BUCKET POSITIONER
      M-4 ADJUSTING BOOM KICK-OUT
      M-5 PROCEDURE FOR STARTING ENGINE
      M-6 INSPECTION OF ALL PARTS
      M-7 PROCEDURE FOR BLEEDING AIR FROM PISTON PUMP
      M-8 BLEEDING AIR FROM WORK EQUIPMENT CIRCUIT
   INSPECTION REPORT