Komatsu WA600-6 (SN from 60001) 4WD Wheeled Loaders (Japan) Field Assembly Manual (GEN00036-02)

Illustrated factory Field Assembly Manual for Komatsu 4WD Wheeled Loaders Models WA600-6.

This manual will assist you in for your 4wd wheeled loader.
You can use a Windows, Mac, or Android device to view this manual. You only need to have a PDF reader installed.

Covered Models (Japan):
   WA600-6 (SN: 60001-)

Format: PDF, 93 pages
Language: English
Table of Contents:
   BLOCK OUTLINE
   PRINCIPAL COMPONENT DIMENSION TABLE
   WORK SPACE LAYOUT
   GENERAL ASSEMBLY SCHEDULE
   LIST OF EQUIPMENT, JIGS, TOOLS AND CONSUMABLES
   OIL, GREASE AND PAINTS
   ASSEMBLY PROCEDURE
      OIL AND COOLANT
      OIL AND COOLANT CAPACITY
      SETTING THE FRONT AXLE AND BARE MACHINE TO STATIONARY POSITION
      INSTALLING THE FRONT AXLE
      CONNECTING THE DRIVE SHAFT
      CONNECTING THE BRAKE PIPE
      CONNECTING THE BRAKE PIPE (BRAKE COOLING SPECIFICATION)
      INSTALLING TIRE AND RIM ASSEMBLY
      INSTALLING STEP
      INSTALLING CAB (1)
      INSTALLING CAB (2) (AJSS SPECIFICATION)
      INSTALLING CAB (2) (STEERING WHEEL SPECIFICATION)
      INSTALLING CAB (2) (AJSS AND STEERING WHEEL SPECIFICATION)
      INSTALLING CAB (3)
      INSTALLING CAB (4) (AJSS SPECIFICATION)
      INSTALLING CAB (4) (STEERING WHEEL SPECIFICATION)
      INSTALLING CAB (5) (STEERING WHEEL SPECIFICATION)
      INSTALLING CAB (6) (AJSS AND STEERING WHEEL SPECIFICATION)
      INSTALLING CAB HARNESS
      INSTALLING CAB DUCT
      INSTALLATION OF YELLOW ROTARY LAMP
      INSTALLING FRONT FENDER
      INSTALLING FRONT LIGHT SUPPORT AND CONNECTION
      INSTALLING MUFFLER STACK AND MIRROR
      INSTALLING COUNTERWEIGHT (STANDARD AND 1 TON HEAVIER COUNTERWEIGHT SPECIFICATIONS)
      INSTALLING COUNTERWEIGHT (LOAD AND CARRY SPECIFICATION)
      INSTALLING PIN (STANDARD AND EU SPECIFICATIONS)
      INSTALLING REAR ACCESS LADDER AND L.H. PLATFORM
      INSTALLING THE LEFT HANDRAIL
      INSTALLING RIGHT PLATFORM AND R.H. HANDRAIL
      INSTALLING FIRE EXTINGUISHER
      INSTALLING THE REAR FENDER MUDGUARD PLATE
      INSTALLING REAR FENDER
      INSTALLING CAB UNDERCOVER
      CHECKING OF SECTIONS
      AIR BLEEDING OF WORK EQUIPMENT HYDRAULIC CIRCUIT AND RESPECTIVE CYLINDERS
      STARTING ENGINE
      BLEEDING AIR FROM BRAKE SYSTEM
      INSTALLING LIFT ARM AND BELL CRANK ASSEMBLY
      INSTALLING BUCKET CYLINDER (BELL CRANK SIDE)
      INSTALLING BUCKET
      GREASING (1ST TIME)
      INSTALLING LIFT ARM POSITIONER
      CONTENTS OF ADJUSTMENT ITEMS
      SETTING OF MACHINE MONITOR
      ADJUSTMENT OF WORK EQUIPMENT CONTROLLER LIFT ARM ANGLE
      ADJUSTMENT OF WORK EQUIPMENT EPC STARTING CURRENT
      ADJUSTMENT OF BUCKET POSITIONER
      ADJUSTMENT OF LOAD METER LIFT ARM ANGLE
      LOAD METER NO-LOAD CALIBRATION
      DELETING THE ELECTRICAL SYSTEM FAILURE HISTORY
      INSTALLING THE FLOOR MAT (AJSS SPECIFICATION)
      INSTALLING THE FLOOR MAT (STEERING WHEEL SPECIFICATION)
      RUNNING-IN PROCEDURE
      GREASING (2ND TIME)
      TOUCH UP WORK
      ON USE OF STARTER KIT (DUMMY HARNESS) AND PRECAUTION ON ITS USE
      STARTER KIT (DUMMY HARNESS) ASSEMBLING PROCEDURE
   FIELD ASSEMBLY INSPECTION REPORT